Summary

How to Run

Arrange the stiffener using Array Along Path or Taped Array.

[Tab] Property

Stiffener Property > Refer Arrangement

[Tab] Array

Array Along Path : Specifies the stiffener arrangement as a path. Only changes to the section above the Rebar Draw Plane are considered and longitudinal section changes are not reflected.
Tapered Array : Specifies the stiffener arrangement criteria for the shape of the object. Reflects the change in the shape of the stiffener according to the longitudinal section change of the side section.
Cancel Array : Restores the arranged stiffeners to the Draw Plane state before the arrangement.

[Select Stiffener]
Select the stiffener to arrange.
[Select Array Main Target Member]
Select the target member on which the selected stiffener will be arranged. The Array Path of the stiffener is recreated from the center line of the Array Target Member.

[Define End Plane]
Defines the end point plane on which the stiffener will be arranged.

[Reference Path of Spacing]
Defines the arrangement path of the stiffener.
- Geometric Line of 1D Member : Specifies the center line of the target member as the array path.
- Select Edge : Select a Line object and set it as the Array path.

Restores the arranged stiffener to the state of the drawplane before the arrangement.

[Tab] Array

[Method]
Select how the stiffeners are arranged.
- Select Cancel Array.
[Select Stiffener]
Select an arranged stiffener group. Multiple stiffener groups can be selected.

The Cancel Array of a single stiffener group can be restored to the Drawplane state by selecting the stiffener group from the Neutral state.