Draw Diaphragm　

Owned by 강연호(Kane)
Last updated: Jun 10, 2024
1 min read

Summary

  • Enter Draw Diaphragm Mode to draw the diaphragm and stiffeners on the plane of the Closed Stiffener.

 

How to Run

  • Ribbon Menu > [Model] Tab > [Component] Group > Stiffener > Draw Diaphragm

 

Explanation

Enter Draw Diaphragm Mode

Select the Closed Stiffener to enter Draw Diaphragm Mode.

 

Manual_Diaphragm(Draw).gif

 

  • [Select Target Member]
    Select the Closed Stiffener object where the diaphragm, manhole, and stiffener reinforcements will be placed.

  • [Target Option]
    Select the type of object to place the reinforcements on.

  • Create from Original Object
    : Creates the plane based on the original object of the target member and enters Draw Mode. The reinforcements will be created on the original object of the target member.

  • Create from Result Object
    : 대상 부재의 적용 객체(Result Object)를 대상으로 평면을 생성하여 Draw Mode로 진입하며, 보강재는 대상 부재의 적용 객체에 생성됩니다.

  • [View Range]
    Define the front and rear visibility range of the defined Draw Plane.

 

Reference Materials