Summary

View or edit property information for classification, geometry, analysis, quantity settings of the Spiral Rebar Group.

How to Run

[Classification]
Set the classification properties of the rebar group.
- Name : Enter the name of the rebar group.
- Rebar Type : Displays the rebar type.
- Grade : Sets the material grade of the rebar group.
[Specification]
Sets the specification of the rebar group.
- Code : Sets the rebar specification.
- Diameter : Select the rebar diameter. This is enabled only when a code is selected.
- Nominal Diameter : Enter the nominal diameter of the rebar.
- Bending Radius : Enter the bending radius of the rebar.
- Maximum Length : Displays the length of the longest rebar within the rebar group.
- Minimum Length : Displays the length of the shortest rebar within the rebar group.

Diameter : This is enabled only when a ‘Code’ is selected.
Nominal Diameter : Once the ‘Diameter’ is set, the nominal diameter is displayed. This can be entered manually only when ‘Code : None’.
Bending Radius : Once the ‘Diameter’ is set, the bending radius is displayed. This can also be input manually.

[Hook]
Set the shape of a hook.
- Differenct Start/End Hook : Set whether to apply hook settings differently to the start and end point of the hook.
- Hook Type : Select the type of hook.
- Angle : Enter the angle of the hook.
- Radius : Enter the radius of the hook.
- Length : Enter the length of the hook.

Differenct Start/End Hook
- Off : Applies same hook settings to start and end point of the hook.
- On : Applies different hook settings to start and end point of the hook. This enables the Start/End Point Tab button.
Hook Type : Select the hook type based on the angle.
- No Hook : The hook is not created.
- Custom Hook : The hook is created based on the hook angle entered by the user.
- ±180°, ±135°, ±90° : The hook is created according to the information specified in ‘Rebar Specification’. For this setting, the angle/radius/length cannot be set manually.

[Cover Thickness]
Sets the cover property that adjusts the position of the rebar group in the member
- On Plane : Enter the rebar cover thickness on the plane. This is at an offset from the line created by the user.
- On Plane Cover Align Center : Set the criteria for ‘On Plane’.
- From Start/End Plane : Enter the rebar cover thickness from the start and end planes.
- From Plane Cover Align Center : Sets the criteria for ‘From Plane’.

Adjustable Spacing : Arrange the rebars using the entered spacing.
- First Spacing : Arrange the rebars using the entered spacing, and then adjust from the first spacing.
- Last Spacing : Arrange the rebars using the entered spacing, and then adjust from the last spacing.
- Middle Spacing : Arrange the rebars using the entered spacing, and then adjust from the middle spacing.
- First/Last Spacing : Arrange the rebars using the entered spacing, and then adjust base on equidistant spacing between the first and last spacing.
Number of Rebars : Arrage the rebars using the number of rebars entered.
Uniform Max. Spacing : Arrage the rebars at equal spacing.
Pattern Spacing : Arrange according to the entered spacing. Do not arrange for any remaining values less than the entered spacing.
- Ex) 3@200, 400, 5@150

[Variable Rebar Name]
Sets the name rule within the rebar group.
- Splice Group : Set the name of each regar group according to the splice group.

Reference - Construction Properties