Longitudinal Stiffener
- 이혜연 (Unlicensed)
- 김선우
Summary
Draws (defines) the Longitude Stiffener on the Draw Plane.
How to Run
[Stiffener Draw Mode]
Ribbon Menu > [Stiffener Draw] Tab > [Stiffener] Group > Draw
Explanation
Single Method
Create longitudinal stiffeners using the Single method.
[Stiffener Type]
Select the type and method of stiffener to be drawn.Select Longitudinal Stiffener.
Select Single.
[Draw Stiffener]
Click the point above the Edge in the Target Member section.Horizontal : Create longitudinal stiffener parallel to the X-axis.
Select Edge Method
Create longitudinal stiffeners using the Select Edge method.
[Stiffener Type]
Select the type and method of stiffener to be drawn.Select Longitudinal Stiffener.
Select Single.
[Draw Stiffener]
Select the Edge of the Target Member section.Horizontal : Longitudinal stiffener generation is parallel to the X-axis.
Reverse Start Point : Switch the start and end points of the longitudinal stiffener profile.
2 Points Method
Create a longitudinal stiffener using the 2 points method.
[Stiffener Type]
Select the type and method of stiffener to be drawn.Select Longitudinal Stiffener.
Select Single.
[Draw Stiffener]
Click the two points above the Edge in the Target Member section. Pick Point 1 is the point in the longitudinal stiffener profile, and Pick Point 2 is the end point.Horizontal : Create longitudinal stiffener parallel to the X-axis.