Transverse Stiffener

Owned by 이혜연 (Unlicensed)
Last updated: Aug 09, 2024 by 김선우
2 min read

Summary

  • Draw (define) a Transverse Stiffener on a plane.

 

How to Run

[Stiffener Draw Mode]

  • Ribbon Menu > [Stiffener Draw] Tab > [Stiffener] Group > Draw

 

Explanation

Select Edge(s) Method

Create lateral stiffener using the Select Edge(s) method.

  • [Stiffener Type]
    Select the type and method of stiffener to be drawn.

    • Select Transverse Stiffener.

    • Select Select Edge(s).

  • [Draw Stiffener]
    Select the Edge of the Target Member section. If the edges are connected, create a continuous stiffener.

    • Reverse Start Point : Apply the stiffener's start and end positions in opposite directions.

 

 

Sketch On Edge Method

Create lateral stiffener using the Sketch On Edge method.

  • [Stiffener Type]
    Select the type and method of stiffener to be drawn.

    • Select Transverse Stiffener.

    • Select Sketch On Edge.

  • [Draw Stiffener]
    Click the two points above the Edge in the Target Member section. Pick Point 1 is the point of stiffener and Pick Point 2 is the end point.

    • Reverse Start Point : Apply the stiffener's start and end positions in opposite directions.

  • Point Alignment on Edge : Sets how to locate the location of the stiffener specified by the user on the edge when the stiffener is arranged.

    • By Ratio : Pick Point 1 and 2 points are stored and arranged as the ratio information above the edge.

    • By Distance : Arranged by storing Pick Point 1 and 2 points as relative position information from the nearest edge of the edge.

 

Reference Materials