Stirrup Rebar

Summary


  • Draw (define) the Stirrup Rebar on the plane.

 

How to Run


[Rebar Draw Mode]

  • Ribbon Menu > [Rebar Draw] Tab > [Rebar] Group > Draw

 

Explanation


How to Draw Stirrup

Creates a stirrup that is subordinate to the transverse or longitudinal rebar.

[Tab] Draw

  • [Rebar Type]
    Select the type and method of rebars to be constructed.

    • Select Stirrup.

  • [Draw Rebar]
    Select the stirrup in the perpendicular direction of the section (transverse/longitudinal rebars) that depend on the rebars.

    • Closed Rebar

      • On : Creates a closed stirrup.

      • Off : Createa a non-closed stirrup.

    • Switch Start Point : Switch the position of the stirrup start and points.

    • Align Bending Center

      • On : Rebars in the perpendicular direction of the section are at the center of the bending part of the stirrup.

      • Off : Rebars in the perpendicular direction of the section in the perpendicular direction of the section are at the end of the straight section of the stirrup.

The target rebar of the stirrup, i.e., the rebar in the perpendicular direction of the section, must be arrayed.


[Tab] Property

Shear Reinforcement Property

 

Reference Materials