Summary
Draw (define) a Transverse Stiffener on a plane.
How to Run
[Stiffener Draw Mode]
Ribbon Menu > [Stiffener Draw] Tab > [Stiffener] Group > Draw
Explanation
Select Edge(s) Method
Create lateral stiffener using the Select Edge(s) method.
Reverse Direction [Stiffener Type]
Select the type and method of stiffener to be drawn.Select Transverse Stiffener.
Select Select Edge(s).
[Draw Stiffener]
Select the Edge of the Target Member section. If the edges are connected, create a continuous stiffener.
| title | Detailed Explanation (Draw Transverse Stiffener) |
|---|
Sketch On Edge : Click the two points above the Edge in the Target Member section to create a lateral stiffener.
Reverse Start Point : Apply the stiffener's start and end positions in opposite directions
Point Alignment on Edge : Sets how to locate the location of the stiffener specified by the user on the edge when the stiffener is arranged.
By Ratio : Pick Point 1 and 2 points are stored and arranged as the ratio information above the edge.
By Distance : Arranged by storing Pick Point 1 and 2 points as relative position information from the nearest edge of the edge.
Sketch On Edge Method
Create lateral stiffener using the Sketch On Edge method.
[Stiffener Type]
Select the type and method of stiffener to be drawn.Select Transverse Stiffener.
Select Sketch On Edge.
[Draw Stiffener]
Click the two points above the Edge in the Target Member section. Pick Point 1 is the point of stiffener and Pick Point 2 is the end point.Reverse Direction Start Point : Apply the stiffener's start and end positions in opposite directions.
| Expand | ||
|---|---|---|
| ||
|