Summary

• This is an annotation creation function available exclusively in CIM View Mode. It expresses coordinate annotations based on CIM model information.

How to Run

[CIM View Mode]

• Ribbon Menu > [INFRA-DESIGN] Tab> Annotation> Coordinate Annotation [CDA]

Explanation

How to use Single Annotation.

Run the Coordinate Annotation [CDA] command or execute the Coordinate annotation function in the annotation section of the INFRA-DESIGN menu tab.

Coordinate Annotation, Shortcut key : CDA	Commentary contents

Coordinate Annotation, Shortcut key : CDA	Commentary contents
Open	[Command] Execute Coordinate Annotation from the tree menu or enter the shortcut key CDA in the command window.
Open	[Command] Set coordinate point : Select the vertex of the object from which coordinate annotation information can be retrieved. Select BASE Point. : If you specify the location where the coordinate annotation will be created, the annotation will be generated.