[Tab] Create

• [Select Master Rebar]
  Select the Master Rebar Group to which the Stirrup Rebar Group will be dependent on. Only Transverse Rebars can be selected as the Master Rebar Group.

  • Select Master : Select the Master Rebar Group.

  • Select Edge : Select the Edge of the Master Rebar Group where you want the Stirrup to be created. If no Edge is selected, the Stirrup will be created on all Edges of the Master Rebar Group.

  • Reverse Direction : Reverse the direction of the transverse array of the Stirrup.

• [Select Slave Rebar]
  Select the Slave Rebar Group to which the Stirrup is dependent. Only Transverse Rebars can be selected as the Slave Rebar Group.

  • Select Slave : Select the Slave Rebar Group.

  • Select Edge : Select the Edge of the Slave Rebar Group where you want the Stirrup to be created. If no Edge is selected, the Stirrup will be created on all Edges of the Slave Rebar Group.

  • Reverse Direction : Reverse the direction of the transverse array of the Stirrup.

• [Closed Stirrup]

  • On : Create a closed stirrup rebar.

  • Off : Create an open stirrup rebar.

• [Align Bending Center]

  • On : The point type rebar is placed at the center of the stirrup rebar bending.

  • Off : The point type rebar is placed at the end of the stirrup rebar line.

• [Switch Start Point]
  Switch the start and end points of the Stirrup rebar.

[Tab] Property