• Select : Selects a rebar group to be ungrouped.

• Ungroup : After selecting the rebar group, if the user clicks on this button, it ungroup the selected rebar group and then changes it to Wire.

• Select : Select the wire object that will be regrouped.

• Regroup : After selecting the Wire and clicking on this button, it will change into a rebar group according to the property information set by the selected Wire.

• Delete Tool : When activated, the selected wire in Regroup is deleted after converting into rebar.

• Select by poly line : When selecting wire, selects it is selected in units of poly line.

• Mirror Hook : Switches the hook start and end points set in the property.

• Reverse Direction : Reverse the direction when it is Offset from the selected wire.

• Name : Specifies the name of the rebar group to be regrouped.

• Class : Used to classify the group of rebar to be regorup.

• Code : Select criteria for rebar specifications. (Application of Spec DB.)

• Grade : Select grade of steel grade based on selected criteria.

• Diameter : Select the rebar diameter based on the criteria selected. It is only active when Code is selected. If Code: None, it is impossible to set.

• Norminal diameter : You can check the actual input of the selected bar diameter.

• Bending radius : The radius value is automatically reflected according to the selected criterion and diameter. You can enter it yourself.

• Spacing : Enter the spacing information for the rebar being regrouped. The value entered here is independent of the actual spacing and is used to display

the spacing values ​​for reinforcing bar annotations when rendering 2D drawings. You can enter a single value or multiple values ​​for the interval value.
(ex. 3@0.2, 0.15, 3@0.3)

• Different start/end hook : If it is activated, hook of start side and end side can be input differently. When activated, the Start point / End point tab button is activated.

• Hook type : Determine Hook Type by angle.
  - No hook : Do not create hooks
  - ±180° : Create a Hook to have a 180 ° Hook.
  - ±135° : Create a Hook to have a 135 ° Hook.
  - ±90° : Create a Hook to have a 90 ° Hook.
  - Custom hook : Create hook with user defined Angle, Radius, Length information.

• Angle : You can check the angle value of the Hook. (Hook angle can be set in case of custom hook setting.)

• Radius : You can check the Bending radius value of the hook. (In case of the Custom hook setting, hook bending radius can be set.)

• Length : You can check the length of the hook (except the bending radius). (Hook length can be set in case of Custom hook setting.)

• Apply hook at splice location : If you enable the option, a hook is created for each rebar splice point.

• On plane cover align center : When enabled, the On plane input value is applied from the center of the rebar to the Cover value.

• On plane : Enter the Cover value on the plane. Offset values ​​can be given separately for each section where the bar is bent. (ex. 20, 30, 40, 50)

• From plane cover align center : When enabled, the From plane input value is applied from the center of the rebar to the Cover value.

• From plane : Enter the Cover value away from the plane in the direction of the rebar arrangement

• Start length : Input the extension length of the starting part of the rebar. If it is a (+) value, it is shortened. and If it is a (-) value, it is lengthened.

• End length : Enter the extension length of the rebar’s end point. If it is a (+) value, it is shortened. and If it is a (-) value, it is lengthened.