개요
Stirrup Rebar Group을 생성합니다.
실행
Ribbon Menu > [Model] Tab > [Component] Group > Rebar > Stirrup
설명
Stirrup 생성
횡철근에 종속되는 스터럽 철근을 생성합니다.
[Tab] Create
[Select Master Rebar]
Stirrup이 종속되는 Master Rebar Group을 선택합니다. Master Rebar Group은 Transverse Rebar만 선택할 수 있습니다.Reverse Direction : Stirrup의 횡방향 배열 진행 방향을 반대로 설정합니다.
[Select Slave Rebar]
Stirrup이 종속되는 Slave Rebar Group을 선택합니다. Slave Rebar Group은 Transverse Rebar만 선택할 수 있습니다.Reverse Direction : Stirrup의 횡방향 배열 진행 방향을 반대로 설정합니다.
[Closed Stirrup]
On : 폐합 스터럽 철근으로 생성합니다.
Off : 폐합되지 않는 스터럽 철근으로 생성합니다.
[Align Bending Center]
On : 스터럽 철근 굽힘(Bending) 부분의 중앙에 점철근이 위치합니다.
Off : 스터럽 철근 직선 부분의 끝에 점철근이 위치합니다.
[Switch Start Point]
스터럽 철근의 시∙종점 위치를 전환합니다.
[Tab] Property