Summary

How to Run

[Stiffener Draw Mode]

Create lateral stiffener using the Select Edge(s) method.

[Stiffener Type]
Select the type and method of stiffener to be drawn.
- Select Transverse Stiffener.
- Select Select Edge(s).
[Draw Stiffener]
Select the Edge of the Target Member section. If the edges are connected, create a continuous stiffener.

Detailed Explanation (Draw Transverse Stiffener)

Sketch On Edge : Click the two points above the Edge in the Target Member section to create a lateral stiffener.
- Reverse Direction : Apply the stiffener's start and end positions in opposite directions.
- Point Alignment on Edge : Sets how to locate the location of the stiffener specified by the user on the edge when the stiffener is arranged.
  - By Ratio : Pick Point 1 and 2 points are stored and arranged as the ratio information above the edge.
  - By Distance : Arranged by storing Pick Point 1 and 2 points as relative position information from the nearest edge of the edge.

Create lateral stiffener using the Sketch On Edge method.

[Stiffener Type]
Select the type and method of stiffener to be drawn.
- Select Transverse Stiffener.
- Select Sketch On Edge.
[Draw Stiffener]
Click the two points above the Edge in the Target Member section. Pick Point 1 is the point of stiffener and Pick Point 2 is the end point.
- Reverse Direction : Apply the stiffener's start and end positions in opposite directions.

Detailed Explanation (Point Alignment on Edge)

Point Alignment on Edge : Sets how to locate the location of the stiffener specified by the user on the edge when the stiffener is arranged.
- By Ratio : Pick Point 1 and 2 points are stored and arranged as the ratio information above the edge.
- By Distance : Arranged by storing Pick Point 1 and 2 points as relative position information from the nearest edge of the edge.