| Table of Contents |
|---|
Feature Summary
...
Rebar Group Setting [Shortcut command: RG]
...
| Table of Contents |
|---|
Summary
...
The Rebar Group Setting is a feature that selects and expresses only the main rebars among the grouped rebars.
Feature Explanation
Generate Drawing > Style > Rebar Group Setting
...
How to Run
...
[CIM View Mode]
Ribbon Menu > [INFRA-DESIGN] Tab> Rebar Group Setting [RG] / Delete Rebar Group Setting [DRG]
Explanation
...
How to Rebar Group Setting
After executing the Rebar Group Setting command, set the main rebar of the group in the order shown in the figure above.
This setting takes precedence over the Group Rebar Type setting of Rebar Style.
| Note |
|---|
Assuming that the position of the main rebar is the 10th in the rebar group, if the number of rebars becomes less than 10 through the model update, the settings are reset. |
...
Rebar Group Setting, Shortcut key : RG | Commentary contents |
|---|---|
|
|
|
|
|
|
|
|
| [Command]
|
| Note |
|---|
After rebar group setting, the settings are initialized when the selected rebar is updated due to a model change, the location changes, or the relevant rebar is deleted. |
...
INFRA-DESIGN > Style > Delete Rebar Group Setting
Delete the main rebar designation setting.
...