Summary

Enter Draw Diaphragm Mode to draw the diaphragm and stiffeners on the plane of the Closed Stiffener.

How to Run

Select the Closed Stiffener to enter Draw Diaphragm Mode.

Manual_Diaphragm(Draw).gif

[Select Target Member]
Select the Closed Stiffener object where the diaphragm, manhole, and stiffener reinforcements will be placed.
[Target Option]
Select the type of object to place the reinforcements on.

Expand

title	상세 설명 (Target Option)

Create from Original Object
: Creates the plane based on the original object of the target member and enters Draw Mode. The reinforcements will be created on the original object of the target member.
Create from Result Object
: 대상 부재의 적용 객체(Result Object)를 대상으로 평면을 생성하여 Draw Mode로 진입하며, 보강재는 대상 부재의 적용 객체에 생성됩니다.

[View Range]
Define the front and rear visibility range of the defined Draw Plane.

참고자료