Summary
평면Draw (Draw Planedefine) 상에서 Stirrup Rebar를 작도(정의)합니다.
the Stirrup Rebar on the plane.
How to Run
[Rebar Draw Mode]
Ribbon Menu > [Rebar Draw] Tab > [Rebar] Group > Draw
Explanation
How to Draw Stirrup
작도 방법횡철근 또는 종철근에 종속되는 띠철근을 생성합니다Creates a stirrup that is subordinate to the transverse or longitudinal rebar.
[Tab] Draw
[Rebar Type]
Stirrup을 선택합니다
작도할 철근의 유형과 방식을 선택합니다.Select the type and method of rebars to be constructed.
Select Stirrup.
[Draw Rebar]
띠철근을 종속시키는 점철근(횡/종철근)을 선택합니다Select the stirrup in the perpendicular direction of the section (transverse/longitudinal rebars) that depend on the rebars.Closed Rebar
On : 폐합 띠철근으로 생성합니다Creates a closed stirrup.
Off : 폐합되지 않는 띠철근으로 생성합니다Createa a non-closed stirrup.
Switch Start Point : 띠철근의 시∙종점 위치를 전환합니다Switch the position of the stirrup start and points.
Align Bending Center
On : 띠철근 굽힘(Bending) 부분의 중앙에 점철근이 위치합니다.
Off : 띠철근 직선 부분의 끝에 점철근이 위치합니다.
Rebars in the perpendicular direction of the section are at the center of the bending part of the stirrup.
Off : Rebars in the perpendicular direction of the section in the perpendicular direction of the section are at the end of the straight section of the stirrup.
| Info |
|---|
The target rebar of the stirrup, i.e., the rebar in the perpendicular direction of the section, must be arrayed. |
[Tab] Property
| Info |
|---|