Summary
Set the options such as units and snap that are applied to the entire CIM.
How to Run
[Base Mode]
Ribbon Menu > [Base] Tab > [Option] Group > Global
[User Section Mode]
Ribbon Menu > [User Section] Tab > [Option] Group > Global
[Point Library Mode]
Ribbon Menu > [Base] Tab > [Option] Group > Global
[Curve Library Mode]
Ribbon Menu > [Base] Tab > [Option] Group > Global
[Assembly Unit Mode]
Ribbon Menu > [Base] Tab > [Option] Group > Global
Explanation
Global Option Setting
Set global options such as force, unit system used to express length, and Snap options.
[Unit System (Force)]
Sets the force unit system to be used by the project.[Unit System (Length)]
Sets the length unit meter to be used by the project.Global : Select the length unit system applied in the remaining modes other than User Section Mode and Draw Mode.
User Section Mode : Select the length unit system that is applied in the User Section Mode.
Draw Mode : Select the length unit system applied in Rebar Draw Mode, Stiffener Draw Mode.
[Unit System (Other)]
Sets the unit to be used to link with midas Drafter.
Creates a drawing in units set, regardless of the unit system of the CIM set above.
[Snap]
You can set up a variety of Snap on/off methods.
[Environment]
This function sets whether the name of the current mode is always displayed on the screen.
When OFF, it is only displayed when the mouse is positioned where the name of the current mode is displayed.
The Global option also applies when you create a new cimz file.