• Vertical Column : Creates a vertical concrete column member.

• General Column : Create a concrete column member of the general type.

Displayed when it is a Vertical Column.

Vertical Column

• Point(Single Point) : Create a point by selecting one point.

• Point(Center of points) : Create a point in the center of the entered sub-points.

General Column

• Line(2 points) : Select two points to create a line.

• By Select(Edge) : Selects and creates lines on the plan drawing.

• Member With Solid : It shows both the center line of the member and its solid shape for the preview shape.

• Member only : Shows only the center line of the member for the preview shape.

• Member type : Select an analysis type of an object for interface with midas Civil.

• Work type : Select the work type.

• Material : Select the material.

• Cardinal point : Sets the position on the cross section corresponding to the center line of the member.

  The section is positioned so that the location on the section you set matches the location of the center line of the member.

• Beta angle : Input the rotation angle of the section.

  The right-hand rule is applied to the Local x-axis of the member (start → end).

• Offset-y : Enter the additional separation distance in the direction of the Local y.

• Offset-z : Enter the additional separation distance in the direction of the Local z.

Displayed when Tapered member is checked ON

• Curve order-y : Sets the curve order for the change of shape in the direction of the Local y-axis.

• Curve order-z : Sets the curve order for the change of shape in the direction of the Local z-axis.