...
Summary
...
...
Set the Section Mark and Scale to be used for the Cutting View.
...
Feature Explanation
...
How to Run
...
[CIM View Mode]
Ribbon Menu > [INFRA-DESIGN] Tab> View > Cutting View > Cutting View Setting
...
Explanation
...
How to use cutting view
The feature can be executed by using the Shortcut Command CUTTINGVIEW CUTTING VIEW SETTING (CVCVS) or by selecting the Cutting View Setting feature in the View tab of the Generate Drawing menu. INFRA-DESIGN menu.
Cutting View Setting, Shortcut key: CVS | Commentary contents |
|---|
 Image Added
| Section Mark Setting Show Section Mark
: Select whether to show the Section Mark when creating a Cutting View.
If this setting is turned off, the existing section mark is also turned off. Show only Start Mark : Displays only one Start Section Mark. Use Different Start/End
: Apply different Section Mark Blocks to the Start and End.
If this setting is turned Off, the End Section Mark selection window is disabled. In addition, the Section Mark of Start is displayed by mirroring the End. Section Mark Block (Start) : Select Start Section Mark Block. Section Mark Block (End) : Select End
|
...
...
Cutting Line Type : Select the type of cutting line between Section Mark Block and Block. Section Mark Text Size : Set the text size of the Section Mark. Section Mark Scale : Set the basic scale of Section Mark. Cutting Line Scale : Sets the scale of the cutting line. Section Mark Layer : Set the Section Mark Layer.
|
