| Table of Contents |
|---|
Overview of Functions
| Info |
|---|
This sets the Global Settings such as Snap. The initial state at the start of the program is determined by the Global Setting that was set up. |
Details of Functions
Control Tab
Default unit system (force)
| Info |
|---|
This sets the force unit in the default state. You are given types of units you can choose from: kgf / tonf / N / kN / lbf / kips |
Default unit system (length)
| Info |
|---|
This sets the length unit of the default state. You can set different units for different situations such as Global / User Section / Rebar draw. Type of units selectable: mm / cm / m / in / ft / um |
Other unit system
| Info |
|---|
This function is to set the force-length unit system applied when providing Drafter and interface. |
Snap
| Info |
|---|
This determines the type of snaps applied relative to the mouse cursor position. |
Grid : Snaps are made at intersections on the grid.
End Point : snap is made at the end point of the line.
Mid Point : A Snap that clings to the center of a 1D object. (Except for cases in a Circle, an Ellipse, or a Spline)
Center : Snaps which are the center of a curved 1D object (Circle, Arc, Ellipse) but also those which cling to the center of a 2D object.
Quadrant : Snaps that cling to the quadrant of curved 1D objects (Circle, Arc, Ellipse).
Nearest : Snaps to arbitrary locations within 0D, 1D, and 2D objects.
Intersection : Snaps clinging to intersections between 1D-1D or 1D-2D objects.
Division : Snaps that cling to the division position of 1D object which is accordingly set by the number of divisions
(Except for cases in a Circle, an Ellipse, or a Spline)
Environment
| Info |
|---|
When checked On, always displays the current mode name on the screen. |