[Classification]
View or edit the classification properties of an object.

• ID : Unique Number

• Name : Name

• Member Type : Member Type

• Material : Material

[Geometry]
객체의 기하 속성을 확인합니다Displays the geometry properties of the object.

[Thickness]
두께를 입력합니다Enter thickness of the 2D member.

[Cardinal Point]
부재의 기하 면(Geometry)을 기준으로 두께가 적용되는 방향을 설정합니다Sets the direction in which the thickness is applied relative to the member geometry.

• Bottom
  기하 면으로부터 부재의 +Z축 방향으로 두께가 적용됩니다.

• Center
  기하 면으로부터 양 방향으로 1/2의 두께가 적용됩니다.

• Top
  기하 면으로부터 부재의 -Z축 방향으로 두께가 적용됩니다The thickness is applied from the member surface in the +Z axis direction.

• Center
  Half of the entered thickness is applied both sides of the member surface.

• Top
  The thickness is applied from the member surface in the -Z axis direction.

[Additional Offset]
Cardinal Point 설정에 따라 두께가 적용된 위치로부터 부재 Z축 방향으로의 추가적인 이격 거리를 입력합니다Enter additional offset in the z-direction from the surface where the thickness is applied based on the cardinal point settings.