Point(Single Point) : Creates a point by inputting one point.

Point(Center of points) : Create a point in the center of the inputted sub-points.

Line(2 points) : Inputs two points to create a line.

Arc(2 points + Angle) : Creates an arc using two points and a center angle.

Arc(2 points + Radius) : Creates an arc using two points and a radius.

Arc(Three points) : Creates an arc using three points.

Arc(Tangent) : Creates an arc in the direction of contact with a 1D object (Line, Arc).

Spline(Interpolation) : Input a number of points on the spline and create a curve using a separate polynomial for each section.

Spline(Control Point) : Creates a curve using a separate polynomial for each section by inputting the spline's starting point, control point, and end point.

Semi-Ellipse : Creates a semi-ellipse by inputting the center of the ellipse, the point along the major axis, and the point along the minor axis.

Rectangle(Center point 1) : Creates a rectangle by inputting the center and one vertex of the rectangle.

Rectangle(Center point 2) : Creates a rectangle by inputting the center of the rectangle and the two corner center points.

Rectangle(Corner two points) : Creates a rectangle by inputting two points diagonally.

Rectangle(Corner three points) : Creates a rectangle by inputting three vertices.

Circle(Ceneter point) : Create a circle by inputting a point on the center and perimeter of the circle.

Circle(Three points) : Create a circle by inputting three points on the perimeter of the circle.

Ellipse(Center point) : Create a circle by inputting the center of the ellipse, a point in the major axis direction, and a point on the perimeter.

Ellipse(Corner point) : Creates an ellipse by inputting two points along the major axis of the ellipse and a point on the perimeter.

Track(Center Point) : Create a track by inputting two points on the track's center and perimeter.

Track(Corner Point) : Create a track by inputting two points on the center and perimeter.

Polygon(Circumscribed) : Creates a polygon tangent to a circumscribed circle.

Polygon(Inscribed) : Creates a polygon tangent to an inscribed circle.

By Select(Edge) : Select the edge directly.

By Select(Plane) : Select the face directly.

Member With Solid : Preview 형상으로 Member의 중심선과 Solid 형상을 모두 나타냅니다This is the preview shape. It shows both the centerline of the member and its solid shape.

Member only : Preview 형상으로 Member의 중심선만을 나타냅니다Shows only the centerline of the member as the preview shape.

Member type : Select a type of analysis for interface with midasCivil.

Work type : Select the work type.

Material : Select the material.